![]() How do I import settings file to GKtwo official slicer?ĭownload RESIONE resins settings and import them into GKtwo official slicer. If you don't find the settings you need here, please replace the Lychee slicer with Anycubic Photo Workshop or Chitubox slicer for best printing results. Resins are produced in special resin cells in plants, and are also produced when an injury occurs to the plant. How do I import settings file to Lychee Slicer?īecause Lychee slicer is missing some setting options or function options of the official slicer of the printer, or the format of the slice file is incorrect, so we only provide a few newly listed printers whose setting options or function options are identical with those of the official slicer. Resins are plant products that, are not soluble in water, harden when exposed to air, do not play a role in the fundamental processes of the plant, and. ![]() If you use the Chitbox slicer, the size of the prints will be smaller than the original model size, but Anycubic Photon Workshop slicer does not have this problem. How do I import settings file to CHITUBOX Slicer?ĭownload CHITUBOX and update the printer firmware ( Some older models of 3d printers may require firmware updates ), then install and open CHITUBOX.Īttention: We recommend that Anycubic printer users only select Anycubic Photon Workshop as a slicer for best printing results. (The above files are in zip file format, please unzip them first) RESIONE resins settings for the following printers: CHITUBOX V1.9.5 or CHITUBOX PRO V1.4.0 or Later.In addition, it is recommended to adjust the printing parameters (increase the "bottom lift distance" and "lifting distance", increase the "rest time after retract") to cope with the printing failure caused by the increase of resin viscosity. Follow the cure time recommendations, 30-60 minutes is normal (I personally use 35) and going below that time can lead to a tacky finish on your prints. If the printer is equipped with a heater, preheat for at least 30 minutes to ensure that the resin fluidity is good before printing. When the ambient temperature is lower than 20 ℃ / 68℉, it is recommended that most RESIONE resins, except W90B and C01 resins, preheat (60-80 ℃ / 140-176℉, 10 minutes) before printing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |